E-Cat SKLep SSM Questions and Answers (March 2023)

On this page you will find the questions submitted to Andrea Rossi about the E-Cat SKLep SSM livestream which started on March 13, 2023.

Hi Andrea, Two questions. 1) Do the units offer internal fuse protection, like a built in reseteable breaker?

YES

Or an external fuse/protection is needed?

NO

2) Can I string (series) multiple units to create a high (~96v) voltage and input to a MPPT controller for battery charging/inverter operation? Thanks!

YES

The headlamp that is used in the livestream, has it been modified in any way and if so, how has it been modified?

WE PUT A LED INSTEAD OF THE ORIGINAL XENON LAMP

Why does the e-cat have to be attached to the headlight with duct tape instead of sitting next to the brand new and unaltered lamp, simply attached with two wires?

THIS IS A PROTOTYPE WHOSE TASK IS SHOW THAT THE ECAT GENERATES ELECTRIC ENERGY, DOESN’T MATTER HOW MUCH, WITHOUT COMSUMING ENERGY. THIS MEANS INFINITE COEFFICIENT OF ENERGY (COP). THEREFORE WE HAVE SHOWN THE WEIGHT, TO MAKE CLEAR THAT A BATTERY OF THE WEIGHT OF THE WHOLE, LAMP INCLUDED, COULD NOT ENDURE MORE YHAN SEVERAL DAYS. THIS IS THE TARGET. THIS CONFIGURATION IS VERY CONSERVATIVE, BECAUSE THE WEIGHT OF THE SOLE ECAT SKLEP SSM IS 40 GRAMS. BESIDE THIS, THERE ARE ALSO RESTRICTED ISSUES.

Congratulation Dr. Rossi on this significant milestone. Q1) Did you test the E-cat SSM with other loads in your lab (e.g., electric heater, charging battery, small DC motor, large AC motor, etc)? Q2) Are you satisfied with the results of such tests? Q3) Would you consider releasing short YouTube videos of such tests (no streaming), just advertisement-like videos to promote the E-cat SSM? Best wishes.
YES
YES
YES

Sir, I would like to know what is the led light temperature and Lumen output?
6000 K- 400 LM

Is the leonardo corporation still working towards miniaturisation of the device? If so hows it going?
R&D ON COURSE- WELL

Q1 Are you working on the SSM version of the 100 W ecat? Q2 Are you working on a home heating ecat device ?
THE 100 W IS JUST 10 x 10W PILED UP

Connecting two or more 100w SSM to a grid tie inverter should they be connected in series or parralle
DEPENDS ON THE VOLTAGE YOU WANT: W=AxV

If you have 400w of SSm’s connected to the grid by a grid tie will they switch off if you switch something on that draws say 1200 watts
DEPENDS ON THE INSTALLATION TO CONNECT THE GRID, TO BE MADE BY A CERTIFIED CONTRACTOR

What is the model of the lamp being used in the live stream? ?
HONDA HEADLIGHT FOR MOTORCYCLE

I want to drive a wind turbine generater with a 12v motor powered by SSM’s is this possible
NONSENSE

Is it possible for at least a redacted version of performance certification to be made public prior to the delivery of orders?
YES

If I hooked up a 12V battery to that light would it be illuminated with the same light output?
YES

How is it possible to achieve a device that outputs a constant power when most power sources either provide a constant voltage over some range of current or provide a constant current over some range of voltage?
YOU ANSWERED BY YOUR QUESTION

Is the SKLep SSM more accurately described as a current generator rather than a voltage generator such that current sets the voltage, constrained within the power limitations of the device? 2a) From the point if view of ZPE field variations or fluctuations and motion, when stationary, can output variations be expected? 2b) Is the rated 10W subject to variations such that 10W be a peak value? 3) If the load is 1ohm will 10A be delivered where the voltage will be a 1V such that nominally 10W is the output? 4) If the load is 10 ohm will 1A be delivered where the voltage will be a 10V such that nominally 10W is the output? 5) As per Q2. Overlooking electric vehicle energy consumption, if the ecat charges an EV battery while in motion would the charge efficiency/ time be different than while stationary?
Answer to 1: no
Answer to 2a : no
Answer to 2b: 10 W is the peak power of a single unit
Answer to 3: yes
Answer to 4: yes
Answer to 5: don’t think so, but this has to be tested

The light we see, is that of a led, or are we looking at the light of the eCat itself?
IT IS A LED

What is the smallest one capable of ? Can it charge a cell phone or a lamp or? What’s the difference between AC & DC as far as these devices are concerned. To be covered, I pre-ordered one of each!! Lol
10 W, THEREFORE 0.X TO 10 W

This question follows a previous five related questions I will attempt to answer it. 6) Is it possible for a single reactor to deliver 100W? Yes, however due to ZPE field variations and density the power output is not consistent and so is unsatisfactory. Reduced to 10W a marked improvement is seen. For this reason 100W unit is constructed from 10 x 10W reactors. At 1W load such as in the present demonstration performance is even better. The SKLep is best suited for charging batteries. Please provide the correct answer.
YOU ARE CORRECT

Can the output voltage for the SSM be adjusted to different levels.
YES

Can three E-cat SKLeps with AC outputs connected in star or delta configurations supply a 3-phase load ?
THESE KIND OF CONNECTIONS ARE DANGEROUS AND MUST BE MADE BY CERTIFIED CONTRACTORS

Will multiple SKLeps with AC outputs to a single bus synchronise as additional SKLeps are addded whilst maintaining frequency and voltage within tolerances?
IT DEPENDS ON THE SPECIFIC SITUATIONS AND ANYWAY THESE CONNECTIONS MUST BE MADE BY A CERTIFIED CONTRACTOR

We are waiting for the e-Cat for a very long time and the world needs your technology urgently. Might I suggest a change in strategy? Start production immediately, whatever isn’t sold directly goes into energy production and will sell electricity to exchanges. Prices in Europe are insane right now, from the revenue you will be able to keep production going easily. In addition you will build trust and credibility by running your own plants (which double as a buffer for production). If you create hot-swappable modules this structure would be easy to maintain. Companies building bitcoin miners have been doing this for years.
THANK YOU FOR THE SUGGESTION

Are you still planning on putting up a second stream in case the YouTube stream goes down? If so, where can we watch the second stream?
WE ARE WORKING ON IT